Basic Safety Tips when using Woden Hydraulic Torque Wrench

Woden Hydraulic Torque Wrench is a very important hydraulic tools that fasten and loosen bolts, mechanical engineering background workers may be familiar with the use of this hydraulic tools.

Most people will find out that it is not difficult to operate a hydraulic torque wrench. However, operators should be cautious when using this high power device as it can be dangerous. 

Below Woden Hydraulic will offer some advice on how to safely use Woden hydraulic torque wrench.

[Exmaine]

Before using Woden Hydraulic Torque Wrench,please make sure that all of Woden hydraulic torque wrench parts are firmly secure.

Once the initial inspection is performed, Woden Hydraulic Torque Wrench will have to be exercised. 

Run it at full scale at least three times before starting the job. This allows the operator to ensure that Woden Hydraulic Torque wrench's movable parts are moving in the right direction.

Woden hydraulic wrench hose connections should be in a free state, not the disk with a diameter of more than five hundred millimeters smaller circle. 

even when using a hydraulic wrench and then are placed at each connection Lubricants.

This method will not only protect the equipment, but also to more provinces strength during use, to extend the service life of Woden Hydraulic Torque Wrenches.

Always check Woden Hydrauli Torque Wrench's sockets to make sure that they are in a quality condition.

Worn out or cracked sockets should never be used as they won't securely hold the wrench's nuts. 

Be sure to operate Woden Hydraulic Torque Wrench within the Woden's advised calibration range. 

If Woden Hydraulic Torque Wrench is used at levels above those specified, the operator will be in danger and Woden Hydraulic Torque Wrench itself might be harmed. 

Be sure to re-calibrate the wrench at consistent intervals.

[Hand]

When the hydraulic wrench work, the hydraulic system can not be touched by hand, pay attention to safety use. 

When the pressure in the machine, it should be left to bleed valve rotation, call open gas valves, and other air inside the machine after all is done and it will be shut down.

[Maintain]

At the end use of the hydraulic wrench,some hydraulic wrench Caution, removing hydraulic wrench quick connector after the first quick connector will change the direction and angle, pushed forward in the direction of the gap.

So that operator can pull out joints, should be exposed to the joint portion is covered with a plastic cover to prevent dust from falling into it. 

Generally, the operator should use conventional hydraulic oil and engine oil system used to work every year for replacement and cleaning, to ensure the quality and life of Woden Hydraulic Torque Wrench.